Runco PL-61DHD Bedienungsanleitung PDF herunterladen (Seite 39)

Runco PlasmaWall Owner’s Operating Manual 29

PRE

IMINAR

4.1

Turning on the Power

1. Turn on your source components.

2. Attach the two ferrite cores supplied with the display to each end of the AC power

cable as shown in

Figure 4-1. Doing so will reduce radio frequency interference (RFI)

emissions to a level that conforms to FCC regulations. Use the supplied plastic bands

to secure the cores in place.

Figure 4-1. Attaching the Ferrite Cores to the Power Cable

3. Plug the female end of the power cord into the AC receptacle on the rear of the

PlasmaWall (AC 100V ~ 240V). Connect the other end to your AC power source.

4. Similarly connect the DHD Controller to a nearby AC outlet.

5. Press the POWER button on the underside of the PlasmaWall. Its power indicator

lights green.

6. Turn on the main power switch at the rear of the DHD Controller.

7. Press the ON button on the remote control to

turn on the DHD Controller (or press the power

button on the front of the DHD Controller). The

power indicator on the DHD Controller lights

solid blue.

8. After a brief warm-up period (approximately 10

seconds), the PlasmaWall will display an image.

4. Operation

Power cable

Ferrite Core

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 71 72

Keine Kommentare

Runco PL-61DHD Bedienungsanleitung Seite 39