Runco XP-103DHD Spezifikationen PDF herunterladen (Seite 61)

Installation

Runco LS-10d and LS-10HBd Installation/Operation Manual 45

PRE

IMINAR

3.11

Installing and

Adjusting the

Anamorphic Lens

If you are installing an LS-10 with an anamorphic lens, proceed as follows to install and

adjust the lens.

Attach the anamorphic lens to the bracket using the plastic knobs supplied with the lens.

See Figure 3-20.

Figure 3-20. Attaching the Anamorphic Lens to the Lens Mount

Configure Lens Motor Trigger on DHD Controller (Optional): The anamorphic lens

solution for the LS-10 maintains constant image height independent of the aspect ratio,

while using the full display resolution of the projector. It accomplishes this by moving the

anamorphic lens in front of the primary lens when widescreen material is being viewed.

When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens

moves out of the light path.

If you are using a trigger on the DHD Controller to control the lens transport motor,

proceed as follows to configure it for proper operation.

1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.

2. On the DHD Controller remote control or front panel, press MENU.

3. Select Service from the Main Menu and enter the Service Menu passcode.

It is extremely important that the primary lens is properly

adjusted before you install the anamorphic lens. Ensure that

the image from the primary lens is perfectly centered on the

screen.

You can skip this step if you connected the lens transport motor to

the TRIGGER 1 output on the LS-10, as shown in Figure 3-15.

Note

You must enter a passcode to access the Service menu for the first

time after turning on the system.

Note

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 125 126

Keine Kommentare

Runco XP-103DHD Spezifikationen Seite 61