Runco REFLECTION CL-510 Spezifikationen PDF herunterladen (Seite 97)

Operation

Runco SC-1 Owner’s Operating Manual 85

PRE

IMINAR

• Film Mode: Enable Film Mode to smooth out moving images from interlaced,

standard-definition (SD) sources. In most cases, the DHD Controller detects the proper

“pull-down” rate and vertical frequency. However, if your source is jittery and/or tearing

you may wish to enable Film Mode to ensure stable processing for that source.

Resolution: When using the SC-1 with a computer or certain HD sources, you may want

to force the DHD Controller to use a specific output resolution. If so, select Resolution

from the Service menu and choose one. Then, press ENTER to confirm.

System Reset: To reset ALL projector and controller settings (including image settings)

back to their factory defaults, select System Reset from the Service menu.

A confirmation message appears, reminding you to save your settings before you perform

the reset, so that you can restore them afterwards. If you have done this, select Confirm to

continue with the reset. Otherwise, select Back to cancel.

Restore Saved Settings: Following a System Reset, select Restore Saved Settings to

apply all previously-saved settings to the projector and DHD Controller.

This action is not undoable. Proceed with caution! Before you

perform a System Reset, save ALL settings, including “Custom” ISF

Presets (

page 79), ISF Day/Night presets (page 81), Output Shift

settings (page 81), Input Names (page 82) and Trigger settings

(page 84).

Caution

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 125 126

Keine Kommentare

Runco REFLECTION CL-510 Spezifikationen Seite 97