Runco SP-42 Bedienungsanleitung PDF herunterladen (Seite 53)

Operation

Runco CinemaWall SP Series Owner’s Operating Manual 43

PRE

IMINAR

Auto Function: The CinemaWall can automatically switch to Input 1 or Input 4 when an

image signal is detected at that input. To enable this feature, select

Auto Function from

the Option menu and set it to INPUT 1 or INPUT 4.

After Auto Function triggers an input switch, when the Input 1 or Input 4 signal is no longer

present, the input source reverts to the previously-selected input.

Option (Installer Adjust

Mode)

Screen Maint.: When in Installer Adjust mode, select Screen Maint. from the Option

menu to program the screen maintenance features of the CinemaWall to operate at

regular intervals. This is useful for preventing image burn-in.

You can program the CinemaWall to switch inputs and/or replace the normal source

signal with a white field, an inverse image or an “orbiting” image. You can specify a time of

day and day of the week when you want this to take place.

To set up a screen maintenance program:

1. Press SET to select the DATE field for the first program. Press or to select one of

the following:

• SUN, MON, TUE, WED, THU, FRI or SAT for a program that runs once only on the

next occurrence of that day.

• * for a program that runs daily.

• *SUN, *MON, *TUE, *WED, *THU, *FRI or *SAT for a program that runs weekly on

that day.

2. Press SET, then followed by SET again to set the program start time.

3. Press or to set the hour component of the start time.

4. Press , then or to set the minute component of the start time.

5. Press SET, then followed by SET again to set the program end time (repeat steps 3

and 4).

6. Press SET, then followed by SET again to specify an input associated with this

program. Choose “–” to specify the input that was active when the CinemaWall was

last powered off.

7. Press SET, then followed by SET again to select the PATTERN field for this

program. Press or to select one of the following:

• Choose “–” to specify the function that was active when the CinemaWall was last

powered off.

• Choose WHITE to display a white field.

• Choose INVERSE to display an inverse image.

• Choose ORBITER to display an “orbiting” image.

8. Press SET.

In order for Auto Function to work correctly on Input 1, the input

signal must be RGB with composite or separate sync. Auto

Function will not work with sync-on-green RGB or component

signals.

When Auto Function is active, selecting an input manually causes

Auto Function to be temporarily disabled. If you cycle power to the

CinemaWall, Auto Function becomes active again.

Note

INPUT 3

INSTALLER ADJ.

SCREEN SET-UP OPTION

PICTURE

PROGRAM TIMER

TEST PATTERN : OFF

SIDEBAR ADJ.

BAUD RATE : 9600BPS

ID NUMBER : ALL

ENTERSET

EXIT

PROGRAM TIMER

DATE ON OFF INPUT PATTERN

* 10:00 – –:– – – –

* 20:00 – –:– – – WHITE

* – –:– – 21:00 – –

– – –:– – – –:– – – –

RETURN

ENTER

SET

EXIT

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

Runco SP-42 Bedienungsanleitung Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Heimkinosysteme Runco SP-42