Runco 3Dimension D-113d Spezifikationen Seite 114

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 152
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 113
Maintenance and Troubleshooting
98 D-113d Projection System Installation/Operation Manual
PRE
L
IMINAR
Y
5. Install the new lamp:
a Take care to align the new lamp properly in the correct orientation inside the lamp
compartment.
b Press firmly on the lamp to properly seat it.
c Secure the lamp by tightening the three (3) captive screws.
6. Close the lamp compartment cover and tighten the captive screw.
7. Re-attach the Left (Exhaust) Side Panel to the projector.
8. Reset the Lamp Hour Counter: Perform the steps listed in Lamp Hours Reset on
page 88.
9. Allow the projector to run for at least five (5) minutes with the new lamp installed.
10. Select Lamp Calibration from the Service -> Display Device - Configure menu. A
confirmation dialog box appears. Select “Yes” to continue with the calibration or “No”
to cancel the operation.
Handle lamps with extreme caution. Dispose of lamps according to
safety regulations for your area. Discard the lamp using safe
disposal/recycling practices or contact your Runco dealer for a
possible re-lamping program.
The lamp will automatically turn on again when the cover is closed.
WARNING
Note
Seitenansicht 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 151 152

Kommentare zu diesen Handbüchern

Keine Kommentare