Runco 3Dimension D-113d Spezifikationen PDF herunterladen (Seite 75)

Installation

D-113d Projection System Installation/Operation Manual 59

PRE

IMINAR

Adjusting the Height (Y): With the alignment pattern still on-screen, loosen the

Height/Y Adjustment T-Screws on either side of the lens. Then, slowly move the

anamorphic lens into place so that there are no shadows on the top or bottom of the

screen.

When the height is properly set, tighten the Height Adjustment T-Screws to secure the

lens in place.

Adjusting the Pitch (Angle): Next, angle the lens to even out any top-to-bottom

pincushion distortion. To do this, loosen the Pitch Adjustment T-Screws (directly below

the Height/Y Adjustment T-Screws) on either side of the lens to allow it to pivot freely.

Then, adjust the anamorphic lens angle so that the projected image is rectangular:

The anamorphic lens will almost always be angled with respect to the projector; this is

normal.

Once the proper lens angle has been set, firmly tighten the Pitch Adjustment T-Screws to

secure the lens in place.

Yaw Adjust: Loosen the Yaw/X-Adjustment Levers to allow the lens to pivot freely from

side to side. Then, angle the lens to even out any left-to-right pincushion distortion:

Once the proper lens angle has been set, firmly tighten the Yaw/X-Adjustment Levers to

secure the lens in place.

There may be some pincushion distortion even after the lens is

properly adjusted, especially at shorter throw distances. If this is the

case, Runco recommends that you slightly over-scan the image

into the screen frame area to mask the distortion.

Correct Lens Angle

Incorrect Lens Angle

Note

Anamorphic Lens (Top View)

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 151 152

Keine Kommentare

Runco 3Dimension D-113d Spezifikationen Seite 75