
Installation
48 D-113d Projection System Installation/Operation Manual
PRE
L
IMINAR
Y
Composite Source Connections: See Figure 3-22.
Figure 3-22. Composite Video Source Connections
Connecting to AC Power Projector: The projector ships with two (2), AC power cords: one for the DHD Controller
and one for the projector. They are not interchangeable. The projector power cord is
rated at 15 amps and has a ferrite sleeve, to reduce radio frequency interference (RFI)
emissions to a level that conforms to FCC regulations:
Plug the female end of the projector power cord into the AC receptacle on the rear of the
projector (AC 100V ~ 240V). Then, connect the other end to your AC power source.
Similarly connect the Primary and Secondary DHD Controller units and the 3Dimension
Processor to nearby AC outlets.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
INPUTS
A
3Dimension
Processor
Component/SCART
Video 1 Video 2
Video 3
Y
PrPb
HDMI 1 HDMI 3
HDMI 2 H I 4
A
DMI
4
Gaming Console
VCR
Camcorder
Composite
Composite
Composite
Composite
Composite
Composite
Use ONLY the AC power cord with the ferrite sleeve to
connect the projector to AC power. Doing otherwise
creates a fire hazard risk.
Ferrite sleeveAC power cord
To power outlet
To Projector AC IN
WARNING
Kommentare zu diesen Handbüchern