Runco REFLECTION Spezifikationen PDF herunterladen (Seite 47)

Installation

Runco RS-1100 Series Owner’s Operating Manual 35

PRE

IMINAR

Configure Lens Motor Trigger: CineWide with AutoScope maintains constant image

height independent of the aspect ratio, while using the full display resolution of the

projector. It accomplishes this by moving the anamorphic lens in front of the primary lens

when widescreen material is being viewed. When the viewer transitions back to 16:9 or

4:3 source material, the anamorphic lens moves out of the light path.

To configure the lens motor trigger on the RS-1100 Ultra for proper AutoScope operation:

1. Press MENU on the remote control.

2. Select Service from the Main menu and press ENTER.

3. Use the number buttons on the remote to enter the Service menu passcode when

prompted and press ENTER again. Then, press MENU on the remote control.

4. Select Screen Trigger Mode from the Service menu.

5. Set the Screen Trigger Mode to “AutoScope.” This enables the lens motor to move

the anamorphic lens into position (in front of the primary lens) when the Cinema or

Virtual Cinema aspect ratio is selected.

6. Select the Cinema or Virtual Cinema aspect ratio to move the anamorphic lens into

position, if it isn’t already. To do this, press CINEMA or VCINE on the RS-1100

remote control (

Figure 2-4).

Adjusting the Horizontal (X) Lens Position:

1. Project a white field on the screen.

2. Loosen the Yaw/X-Adjustment Levers underneath the lens.

3. Slowly move the anamorphic lens into place (from right to left or vice versa) so that

there are no shadows on either side of the screen:

4. When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to

secure the lens in place.

Adjusting the Height (Y): With the white field still on-screen, loosen the

Height/Y

Adjustment T-Screws on either side of the lens. Then, slowly move the

anamorphic lens into place so that there are no shadows on the top or bottom of the

screen:

Too Far Right

Too Far Left

Correct position

Downloaded From projector-manual.com Runco Manuals

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 91 92

Keine Kommentare

Runco REFLECTION Spezifikationen Seite 47