Runco RS-900 CineWide Bedienungshandbuch PDF herunterladen (Seite 46)

Installation

30 RS-900 and RS1100 Series Installation/Operation Manual

PRE

IMINAR

1. Place the projector upside down on a blanket or other soft surface.

2. Install a nylon spacer (item #3) at each mounting hole location.

3. Place the CineWide base plate (item #2) on the bottom of the projector. For a

standard RS-900/CineWide or RS1100/CineWide, position the plate as shown in

Figure 3-11; for an RS1100 Ultra/CineWide, position the plate as shown in Figure

3-12.

4. If you are mounting the projector on a ceiling: Line up the four holes on the

projector ceiling mounting plate (included with the projector ceiling mount kit) with

those on the bottom of the projector and CineWide base plate.

5. Secure the CineWide base plate (and ceiling mounting plate, if needed) to the

projector with the M6x12mm screws (item #1) and nylon spacers provided with the

CineWide lens base plate.

3.5

Mounting the

RS-900/RS1100

There are several methods for mounting the projector. Depending on your chosen

installation, one method may be more suitable than another.

Floor Mounting (Upright) In typical front and rear screen installations, the projector can be mounted to a secure and

level surface such as a table or cart. Carts are useful when moving a projector during a

presentation or from site to site. If possible, lock the wheels when it’s in position to prevent

it from being moved during a presentation.

Ceiling Mounting

(Inverted)

For fixed installations, and for those that want the projector out of sight or have a limited

space for projector and audience, you can invert the RS-900/RS1100 and suspend it from

the ceiling using a specially-designed ceiling mount fixture.

The projector can also be inverted and placed in an enclosure above and behind the

viewing area. Install four feet on the inside bottom surface of the enclosure on which the

projector can rest. A variety of materials can be used for this purpose (for example, rubber

crutch tips or turntable feet).

Adjusting the Projector

Height or Projection Angle

If the screen is significantly higher or lower than the projector, you can also tilt the

projector at a slight angle. In a ceiling installation, you do this by adjusting the ceiling

mount.

1. Do not use the mounting screws provided with the ceiling

mounting plate. Use only the hardware provided with the

CineWide lens base plate.

2. DO NOT OVER-TIGHTEN THE SCREWS.

Caution

➤

Use only the Runco-approved ceiling mount kit designed for your

projector. Install the mount kit according to the instructions

provided with it.

Note

➤

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 103 104

Kommentare zu diesen Handbüchern

Keine Kommentare

Runco RS-900 CineWide Bedienungshandbuch Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Datenprojektoren Runco RS-900 CineWide