Runco RS-900 CineWide Bedienungshandbuch PDF herunterladen (Seite 22)

Controls and Functions

6 RS-900 and RS1100 Series Installation/Operation Manual

PRE

IMINAR

4. TEMP LED

Indicates fan status and internal temperature as follows:

• Off during normal operation

• Red when internal temperature is too high or a fan failure occurs

5. INTAKE VENT

6. POWER/STANDBY LED

Indicates power status as follows:

• Orange when the projector is in standby mode

• Flashes green for approximately 45 seconds after the projector is turned on to

indicate that the lamp is warming up

• Green during normal operation

• Flashes orange for approximately 110 seconds after the projector is turned off to

indicate that the lamp is cooling down

• Red when an internal failure requiring service has occurred

7. LAMP LED

Indicates lamp status as follows:

• Off during normal operation

• Red when the lamp has exceeded its usage life or developed a problem

8. RUNCO LOGO

The logo can be rotated to match the projector orientation: inverted (ceiling-mounted)

or upright. To rotate the logo, grip it at the sides, pull it away from the projector and

rotate it 180 degrees.

9. FRONT IR SENSOR

10. FOCUS RING (Standard RS-900/RS1100)

To adjust the focus, grasp the lens by the outer ring and rotate it. (Use the remote

control unit to adjust the focus with an RS1100

Ultra.)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 103 104

Keine Kommentare

Runco RS-900 CineWide Bedienungshandbuch Seite 22