Runco RS-900 CineWide Bedienungshandbuch PDF herunterladen (Seite 61)

Installation

RS-900 and RS1100 Series Installation/Operation Manual 45

PRE

IMINAR

Whitney (Prismatic)

Anamorphic Lens

Installation and

Adjustment

The Whitney Anamorphic lens mount kit consists of everything shown in Figure 3-22.

Some components shipped with your projector may differ slightly from what is shown in

these instructions.

Figure 3-22. Prismatic Anamorphic Lens Mounting Assembly - Exploded View

1. Use the Pitch Adjustment Screws and Washers (item #6) to attach the Vertical

Mounting Brackets (item #5) to the Anamorphic Lens (item #1).

2. Place the lens with the brackets installed on top of (or under, if the projector is

inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the

brackets pass through the corresponding slots on the base plate.

3. Secure the lens assembly to the base plate with the Yaw/Z-Adjustment Knobs and

Washers (item #4).

To avoid clipping the corners of the image, position the anamorphic

lens as close as possible to the primary lens.

2 Base Plate

5 Vertical Mounting

Bracket (2x)

6 Pitch/Y-Adjustment

Screw, Phillips

Pan Head, 4-40 x 3/8”

(4x) and Fender

Washer (4x)

4 Yaw/Z-Adjustment

Knob (2x) and

Washer (2x)

1 Anamorphic Lens

3 Screw, Phillips

M6x16mm (2x) and

1/4” Flat Washer (2x)

(not shown; secures Base Plate

to bottom of projector)

Tip

Ceiling Mount

Bracket

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 103 104

Keine Kommentare

Runco RS-900 CineWide Bedienungshandbuch Seite 61