Runco RS-900 CineWide Bedienungshandbuch PDF herunterladen (Seite 85)

RS-900 and RS1100 Series Installation/Operation Manual 69

PRE

IMINAR

5.1

Lamp Replacement

The lamp should be replaced when it reaches the end of its life (typically 2000 hours), or

sooner if a noticeable degradation in brightness occurs. Contact your Runco dealer to

obtain a replacement lamp.

1. Turn off the projector and unplug the power cord.

Allow the projector to cool down for

approximately 45 minutes prior to removing

the lamp assembly for replacement.

2. Loosen the two captive screws from the lamp

cover.

3. Remove the lamp cover.

4. Remove the two lamp assembly mounting screws.

5. Grasp the lamp assembly handle and pull gently,

removing the lamp module from the projector

housing.

6. Install the new lamp module and replace the two

screws.

7. Replace the lamp cover at the right side first and

secure it with the two screws.

8. Turn on the power and select Lamp Hours from the

Setup menu to reset the lamp timer (refer to Lamp

Hours on page 63).

5. Maintenance and Troubleshooting

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 103 104

Keine Kommentare

Runco RS-900 CineWide Bedienungshandbuch Seite 85